diff --git a/dts/Bindings/interrupt-controller/snps,archs-idu-intc.txt b/dts/Bindings/interrupt-controller/snps,archs-idu-intc.txt
index 0dcb7c7..9446576 100644
--- a/dts/Bindings/interrupt-controller/snps,archs-idu-intc.txt
+++ b/dts/Bindings/interrupt-controller/snps,archs-idu-intc.txt
@@ -15,6 +15,9 @@
   Second cell specifies the irq distribution mode to cores
      0=Round Robin; 1=cpu0, 2=cpu1, 4=cpu2, 8=cpu3
 
+  The second cell in interrupts property is deprecated and may be ignored by
+  the kernel.
+
   intc accessed via the special ARC AUX register interface, hence "reg" property
   is not specified.
 
diff --git a/dts/Bindings/net/mediatek-net.txt b/dts/Bindings/net/mediatek-net.txt
index c010faf..c7194e8 100644
--- a/dts/Bindings/net/mediatek-net.txt
+++ b/dts/Bindings/net/mediatek-net.txt
@@ -7,7 +7,7 @@
 * Ethernet controller node
 
 Required properties:
-- compatible: Should be "mediatek,mt7623-eth"
+- compatible: Should be "mediatek,mt2701-eth"
 - reg: Address and length of the register set for the device
 - interrupts: Should contain the three frame engines interrupts in numeric
 	order. These are fe_int0, fe_int1 and fe_int2.
diff --git a/dts/Bindings/net/phy.txt b/dts/Bindings/net/phy.txt
index ff1bc4b..fb5056b 100644
--- a/dts/Bindings/net/phy.txt
+++ b/dts/Bindings/net/phy.txt
@@ -19,8 +19,9 @@
   specifications. If neither of these are specified, the default is to
   assume clause 22.
 
-  If the phy's identifier is known then the list may contain an entry
-  of the form: "ethernet-phy-idAAAA.BBBB" where
+  If the PHY reports an incorrect ID (or none at all) then the
+  "compatible" list may contain an entry with the correct PHY ID in the
+  form: "ethernet-phy-idAAAA.BBBB" where
      AAAA - The value of the 16 bit Phy Identifier 1 register as
             4 hex digits. This is the chip vendor OUI bits 3:18
      BBBB - The value of the 16 bit Phy Identifier 2 register as