plat/arm: Implement ARMv8.3-PAuth interfaces ...

This feature is only supported on FVP.

Change-Id: I4e265610211d92a84bd2773c34acfbe02a1a1826
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

Merge pull request #1834 from thloh85-intel/s10_bl31 ...

plat: intel: Add BL31 support to Intel Stratix10 SoCFPGA platform

Merge pull request #1826 from smaeul/allwinner ...

allwinner: A few minor improvements

plat: intel: Add BL31 support to Intel Stratix10 SoCFPGA platform ...

This adds BL31 support to Intel Stratix10 SoCFPGA platform. BL31 in TF-A
supports:
- PSCI calls to enable 4 CPU cores
- PSCI mailbox calls for FPGA reconfiguration

Signed-off-by: Loh Tien Hock <tien.hock.loh@intel.com>

Merge pull request #1836 from Yann-lms/docs_and_m4 ...

Update documentation for STM32MP1 and add Cortex-M4 support

Merge pull request #1835 from jts-arm/rename ...

Apply official names to new Arm Neoverse cores

Merge pull request #1828 from uarif1/master ...

Introduce Versatile Express FVP platform to arm-trusted-firmware.

stm32mp1: add minimal support for co-processor Cortex-M4 ...

STM32MP1 chip embeds a dual Cortex-A7 and a Cortex-M4.
The support for Cortex-M4 clocks is added when configuring the clock tree.
Some minimal security features to allow communications between A7 and M4
are also added.

Change-Id: I60417e244a476f60a2758f4969700b2684056665
Signed-off-by: Yann Gautier <yann.gautier@st.com>

rcar_gen3: plat: Prevent PCIe hang during L1X config access ...

In case the PCIe controller receives a L1_Enter_PM DLLP, it will
disable the internal PLLs. The system software cannot predict it
and can attempt to perform device config space access across the
PCIe link while the controller is in this transitional state. If
such condition happens, the PCIe controller register access will
trigger ARM64 SError exception.

This patch adds checks for which PCIe controller is enabled,
checks whether the PCIe controller is in such a transitional
state and if so, first completes the transition and then restarts
the instruction which caused the SError.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>

plat/arm: Support for Cortex A5 in FVP Versatile Express platform ...

Cortex A5 doesnt support VFP, Large Page addressing and generic timer
which are addressed in this patch. The device tree for Cortex a5
is also included.

Change-Id: I0722345721b145dfcc80bebd36a1afbdc44bb678
Signed-off-by: Usama Arif <usama.arif@arm.com>

plat/arm: Introduce FVP Versatile Express platform. ...

This patch adds support for Versatile express FVP (Fast models).
Versatile express is a family of platforms that are based on ARM v7.
Currently this port has only been tested on Cortex A7, although it
should work with other ARM V7 cores that support LPAE, generic timers,
VFP and hardware divide. Future patches will support other
cores like Cortex A5 that dont support features like LPAE
and hardware divide. This platform is tested on and only expected to
work on single core models.

Change-Id: I10893af65b8bb64da7b3bd851cab8231718e61dd
Signed-off-by: Usama Arif <usama.arif@arm.com>

Rename Cortex-Helios to Neoverse E1 ...

Change-Id: I1adcf195c0ba739002f3a59e805c782dd292ccba
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Rename Cortex-Ares to Neoverse N1 ...

Change-Id: Ideb49011da35f39ff1959be6f5015fa212ca2b6b
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Rename PLAT_ARM_BL31_RUN_UART* variable ...

The variable is renamed to PLAT_ARM_RUN_UART as
the UART is used outside BL31 as well.

Change-Id: I00e3639dfb2001758b7d24548c11236c6335f64a
Signed-off-by: Usama Arif <usama.arif@arm.com>

Merge pull request #1824 from antonio-nino-diaz-arm/an/move-dyn-xlat ...

fvp: trusty: Move dynamic xlat enable to platform

allwinner: Clean up CPU ops functions ...

Convert them to take an mpidr instead of a (cluster, core) pair. This
simplifies all of the call sites, and actually makes the functions a bit
smaller.

Signed-off-by: Samuel Holland <samuel@sholland.org>

allwinner: Constify data structures ...

This maximizes the amount of data protected by the MMU.

Signed-off-by: Samuel Holland <samuel@sholland.org>

stm32mp1: update clock driver ...

Remove useless private structure in function prototypes.
Add a reference counter on clocks.
Prepare for future secured/shared/non-secured clocks.

Change-Id: I3dbed81721da5ceff5e10b2c4155b1e340c036ee
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Lionel Debieve <lionel.debieve@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

stm32mp1: use functions to retrieve some peripheral addresses ...

PWR, RCC, DDRPHYC & DDRCTRL addresses can be retrieved from device tree.
Platform asserts the value read from the DT are the SoC addresses.

Change-Id: I43f0890b51918a30c87ac067d3780ab27a0f59de
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

stm32mp1: split clkfunc code ...

Create a new file stm32mp_clkfunc.c to put functions that could be common
between several platforms.

Change-Id: Ica915c796b162b2345056b33328acc05035a242c
Signed-off-by: Yann Gautier <yann.gautier@st.com>

stm32mp1: update I2C and PMIC drivers ...

Regulator configuration at boot takes more information from DT.
I2C configuration from DT is done in I2C driver.
I2C driver manages more transfer modes.
The min voltage of buck1 should also be increased to 1.2V,
else the platform does not boot.

Heavily modifies stm32_i2c.c since many functions move inside the source
file to remove redundant declarations.

Change-Id: I0bee5d776cf3ff15e687427cd6abc06ab237d025
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Lionel Debieve <lionel.debieve@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

Introduce timeout_init_us/timeout_elapsed() delay tracking with CNTPCT. ...

timeout_init_us(some_timeout_us); returns a reference to detect
timeout for the provided microsecond delay value from current time.

timeout_elapsed(reference) return true/false whether the reference
timeout is elapsed.

This change is inspired by the OP-TEE OS timeout resources [1].

 [1] https://github.com/OP-TEE/optee_os/blob/3.4.0/core/arch/arm/include/kernel/delay.h#L45

Change-Id: Id81ff48aa49693f555dc621064878417101d5587
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@linaro.org>

stm32mp1: remove some dependencies on clocks and reset in drivers ...

Include all RCC, clocks and reset headers from stm32mp1_def.h
which if exported to the firmware through platform_def.h.
The same dependency removal is done in common code as well.
Some useless includes are also removed in stm32_sdmmc2 driver.

Change-Id: I731ea5775c3fdb7f7b0c388b93923ed5e84b8d3f
Signed-off-by: Yann Gautier <yann.gautier@st.com>

stm32mp1: make functions and macros more common ...

Mainly remove suffix 1 from prefix stm32mp1 in several macros and functions
that can be used in drivers shared by different platforms.

Change-Id: I2295c44f5b1edac7e80a93c0e8dfd671b36e88e7
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>

stm32mp1: split code between common and private parts ...

Some parts of code could be shared with platform derivatives,
or new platforms.
A new folder plat/st/common is created to put common parts.

stm32mp_common.h is a common API aggregate.

Remove some casts where applicable.
Fix some types where applicable.
Remove also some platform includes that are already in stm32mp1_def.h.

Change-Id: I46d763c8d9e15732d1ee7383207fd58206d7f583
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>

Merge pull request #1819 from thloh85-intel/integration ...

plat: intel: Fix faulty DDR calibration value

Merge pull request #1813 from oscardagrach/hikey960-iomcu-dma ...

hikey960: enable IOMCU DMAC

Merge pull request #1816 from grandpaul/paulliu-warp7-multiconsoleapi ...

imx: warp7: Migrate to MULTI_CONSOLE_API

plat: intel: Fix faulty DDR calibration value ...

A DDR calibration value is missing write mask, causing ECC DDR calibration
to fail. This patch addresses the issue. ECC should also be scrubbed before
MMU initializes, thus the scrubbing is moved to ddr intialization phase.

Signed-off-by: Loh Tien Hock <tien.hock.loh@intel.com>

fvp: trusty: Move dynamic xlat enable to platform ...

Rather than letting the Trusty makefile set the option to enable dynamic
translation tables, make platforms do it themselves.

This also allows platforms to replace the implementation of the
translation tables library as long as they use the same function
prototypes.

Change-Id: Ia60904f61709ac323addcb57f7a83391d9e21cd0
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>