Three variants of the Wandboard exist: WBSOLO, WBDUAL and WBQUAD.
For all variants, the external serial port is connected to UART1 via
PAD_CSI0_DATA10 (TX) and PAD_CSI0_DATA11 (RX). Unfortunately, the IOMUX
register adresses for this mux differ between i.MX6Q (WBQUAD) and others.
Make the UART IOMUX for PBL compatible for WBQUAD.

Signed-off-by: Alexander Kurz <akurz@blala.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

The hardware requirements to perform a write leveling calibration are
not fulfilled by the Wandboard modules.
IMX6DQRM §44.11.6 "Write leveling Calibration" Note2 states that the first
bit of each data byte group (D0, D8, ..., D56) from memory must be connected
to the same data bus bit on the controller, which is not given on the
Wandboard modules, resulting in unpredictable calib results and breaking the
WBQUAD 2GiB SDRAM setup. Similar restrictions exist for the i.MX6SD.

Remove this calibration and use the MPWLDECTRL defaults.

Signed-off-by: Alexander Kurz <akurz@blala.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

This adds support support for the i.MX6 Technexion Wandboard. The
board comes in different SoC variants and different amounts of RAM.
The baord type is autodetected based on the SoC type, so all boards
can be supported by the same binary image.

Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>