The new MMU setup will need SDRAM base addresses and sizes.
For this reason convert the MMU enabled ARM boards:

- move mem setup to mem_initcall. This is early but
  still makes sure that we already have the console available
- move MMU setup in this initcall temporary as after the mmu_init will generic

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

this will automaticaly register the device to armlinux_add_dram

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

Add a helper function for boards to register their memory
devices. This makes the board code smaller and also helps
getting rid of map_base and struct memory_platform_data.

And switch all of the memory to it

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

we keep struct memory_platform_data for now on we will switch off the memories
resources to struct resource

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

When booting from NAND, its important to know the correct page size. When
the NAND is used as the boot source, four dedicated pins are used to configure
the correct page size and address cycles. These pins can be read back in one
of the NFC registers to parametrize the load function.

This patch also extends the read routine to support more than four address
cycles on demand.

BTW: At least some mini2440s are misconfigured to use five address cycles for
a NAND device that is known to need only four address cycles. In this case the
vendor is at our side: This NAND simply ignores any additional address cycles
than required.

Signed-off-by: Juergen Beisert <jbe@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

before if you specify id = 0 the next available id will be taken
otherwise fail if already registered now as in linux we use -1

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>

this will allow each arch to handle the boards more simply and depending on
there need

the env var BOARD will refer to the current board dirent

for sandbox as we have only one board the board dirent is arch/sandbox/board

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>