net: rtl8139: depend on MIPS ...

Until we sort out the dma-mapping mess.

Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: ethoc: depend on OPENRISC ...

This driver currently only works on OpenRISC, as it uses
the cache flush/invalidate functions of this arch.

Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Merge branch 'for-next/tegra'

Merge branch 'for-next/misc'

net: rtl8169: clean receive buffer after net handler ...

The processing of the buffer might change some data, which
will eventually trigger a cache writeback later on, corrupting
data written by the network chip. Clean the cache range
to make sure there is no writeback pending.

Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: rtl8169: add support for RTL-8168/8111g ...

This is the version of the chip found on Jetson-TK1.

Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: cpsw: Set phy device_node pointer in probe ...

Set the phy device_node pointer to the equivalent cpsw slave node.
We need this, because phy drivers using this pointer for their configuration.

Create and register the phy device in cpsw_probe(), so that this phy device
can be found later by phy_device_connect() in cpsw_open().

Signed-off-by: Wadim Egorov <w.egorov@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: phy: micrel: Add OF conf. support for ksz9031 ...

Adds support for ksz9031 PAD skew configuration over devicetree.
Based on a patch from the linux kernel.

Author: Hubert Chaumette <hchaumette@adeneo-embedded.com>
Original commit: 6e4b827

Signed-off-by: Wadim Egorov <w.egorov@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: cpsw: Fix probe for one port ethernet ...

If only one port is pinned out, probe fails
as the second port phy_id is not found.

Signed-off-by: Teresa Gámez <t.gamez@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: micrel: Add ksz8081 support ...

Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: cpsw: Allow gigabit connection ...

Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: add rtl8169 driver ...

This adds the driver for RealTek 8169 and compatible
pci attached network chips.

Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

Merge branch 'for-next/resource-err-ptr'

Merge branch 'for-next/phycore-imx6'

Merge branch 'for-next/openrisc'

Merge branch 'for-next/net-phy'

Merge branch 'for-next/misc'

Merge branch 'for-next/imx'

Merge branch 'for-next/at91'

net: macb: enable GEM with only FE feature ...

If the GEM is used, however only FE featuren enabled, then it can not
support FBLDO configured as 16, and no RGMII/GMII configuratin bit.

So, in order to support GEM only with FE feature enabled, we do:
  - using default value for FBLDO.
  - using same bit for RMII/MII configuration as GEM for RGMII/GMII.

Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: asix: handle packets crossing URB boundaries ...

ASIX AX88772B started to pack data even more tightly. Packets and the ASIX packet
header may now cross URB boundaries. To handle this we have to introduce
some state between individual calls to asix_rx_fixup().

Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
[ Rolf: ported from kernel to barebox 2014.09.0 ]
Signed-off-by: Rolf Evers-Fischer <embedded24@evers-fischer.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: phy: don't use 'dev' as name for variables of type struct phy_device ...

Using 'dev' as name for variables which are not of type
struct device(_d) is bad habit and leads to confusions. Use phydev
instead.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: phy: Use xzalloc for small allocations ...

No need to call kzalloc for small allocations, xzalloc will do without
the need for an additional check.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: phy: introduce phy_aneg_done ...

phy_wait_aneg_done() is directly called by the network code, so it
should not read phy registers directly. Introduce phy_aneg_done to
give phy drivers the chance to do something different to poll for
autonegotiation completion.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

phy: marvell: move IDs to own header ...

So they can be used in board files to register
fixups.

Signed-off-by: Lucas Stach <dev@lynxeye.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

phy/micrel: disable Asym_Pause support ...

With SUPPORTED_Asym_Pause enabled we need to hotplug the ethernet cable.
So disable it like done with PHY_ID_KSZ9021.

Signed-off-by: Jan Weitzel <j.weitzel@phytec.de>
Signed-off-by: Christian Hemp <c.hemp@phytec.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

resource: Let dev_request_mem_region return an error pointer ...

For all users fix or add the error check.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

resource: Let dev_get_mem_region return an error pointer ...

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Acked-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>

net: dm9k: fix copy-paste typo ...

Signed-off-by: Antony Pavlov <antonynpavlov@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

net: ethoc: add device tree support ...

Signed-off-by: Antony Pavlov <antonynpavlov@gmail.com>
Cc: Franck Jullien <franck.jullien@gmail.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>