/* mbed Microcontroller Library * (C)Copyright TOSHIBA ELECTRONIC DEVICES & STORAGE CORPORATION 2018 All rights reserved * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include "reset_reason_api.h" #ifdef DEVICE_RESET_REASON #include "TMPM46B.h" #include <stdbool.h> static uint8_t set_bit_count(uint32_t reg); static uint8_t bit_pos(uint32_t reg); static reset_reason_t reset_reason[7] = { RESET_REASON_PIN_RESET, RESET_REASON_UNKNOWN, RESET_REASON_WATCHDOG, RESET_REASON_WAKE_LOW_POWER, RESET_REASON_SOFTWARE, RESET_REASON_UNKNOWN, RESET_REASON_BROWN_OUT }; void hal_reset_reason_clear(void) { TSB_CG->RSTFLG = 0x00; } uint32_t hal_reset_reason_get_raw(void) { uint32_t ret = 0; ret = TSB_CG->RSTFLG; return ret; } reset_reason_t hal_reset_reason_get(void) { reset_reason_t ret; uint8_t NoOfSetBitCountReg = set_bit_count(TSB_CG->RSTFLG); if (NoOfSetBitCountReg != 0x00) { if (NoOfSetBitCountReg > 0x01) { ret = RESET_REASON_MULTIPLE; } else { ret = reset_reason[bit_pos(TSB_CG->RSTFLG)]; } } else { ret = RESET_REASON_UNKNOWN; } return ret; } void hal_reset_reason_get_capabilities(reset_reason_capabilities_t *cap) { cap->reasons = 1 << RESET_REASON_UNKNOWN; cap->reasons |= 1 << RESET_REASON_MULTIPLE; } static uint8_t set_bit_count(uint32_t reg) { uint8_t count = 0; uint8_t index = 0; for (index = 0; index < (sizeof(uint32_t) * 8); index++) { if ((reg & (1 << index)) && index != 1) { count++; } } return count; } static uint8_t bit_pos(uint32_t reg) { uint8_t bit_no = 0; for (bit_no = 0; bit_no < (sizeof(uint32_t) * 8); bit_no++) { if ((reg & (1 << bit_no)) && bit_no != 1) { return bit_no; } } return 0; } #endif // DEVICE_RESET_REASON