Merge pull request #1205 from petegriffin/hikey-protect-memory ...

Hikey protect optee / sdp memory

rockchip: Disable rdist before pwr_dm_suspend is called ...

This disables the redistributor before either of the pwr_dm_suspend
functions are called. This is because the rdist save code in the
rk3399 rockchip_soc_sys_pwr_dm_suspend function requires that each
redistributor be disabled before saving state.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

delay_timer: Guarantee that delay time can never be undershot ...

Delay functions like udelay() are often used to ensure that the
necessary time passed to allow some asynchronous event to finish, such
as the stabilization delay for a power rail. For these use cases it is
not very problematic if the delay is slightly longer than requested,
but it is critical that the delay must never be shorter.

The current udelay() implementation contains two hazards that may cause
the delay to be slightly shorter than intended: Firstly, the amount of
ticks to wait is calculated with an integer division, which may cut off
the last fraction of ticks needed. Secondly, the delay may be short by a
fraction of a tick because we do not know whether the initial ("start")
sample of the timer was near the start or near the end of the current
tick. Thus, if the code intends to wait for one tick, it might read the
timer value close to the end of the current tick and then read it again
right after the start of the next tick, concluding that the duration of
a full tick has passed when it in fact was just a fraction of it.

This patch rounds up the division and always adds one extra tick to
counteract both problems and ensure that delays will always be larger
but never smaller than requested.

Change-Id: Ic5fe5f858b5cdf3c0dbf3e488d4d5702d9569433
Signed-off-by: Julius Werner <jwerner@chromium.org>

Merge pull request #1232 from masahir0y/uniphier ...

uniphier: migrate to BL2-AT-EL3

Merge pull request #1234 from SNG-ARM/master ...

SPM: Declare explicit width based types in secure_partition_boot_info…

Merge pull request #1231 from Leo-Yan/hikey960_enable_fiq_handling ...

Hikey960: Enable invalid FIQ handling

Merge pull request #1228 from dp-arm/dp/cve_2017_5715 ...

Workarounds for CVE-2017-5715 on A9/A15 and A17 + serial console reporting

Merge pull request #1223 from vchong/poplar_bl1loadsfip ...

poplar: Enable emmc and recovery build support

Merge pull request #1193 from jwerner-chromium/JW_coreboot ...

New console API and coreboot support [v4]

uniphier: switch to BL2-AT-EL3 and remove BL1 support ...

UniPhier platform implements non-TF boot ROM.  Prior to the BL2-AT-EL3
support, BL1 (worked as a pseudo ROM) was needed just for ensuring BL2
is entered at EL1-S.  Now, this platform is able to avoid this waste.

Enable the BL2_AT_EL3 option, and remove BL1.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

uniphier: set PROGRAMMABLE_RESET_ADDRESS to disable warm boot mailbox ...

The warm boot mailbox code is compiled if PROGRAMMABLE_RESET_ADDRESS
is disabled.

The warm boot mailbox is useless for UniPhier SoC family because BL1
is not the first image.  The UniPhier platform implements non-TF ROM,
then BL1 works as a pseudo ROM, so it is never executed in the warm
boot.

The reset vector address is not actually programmable for UniPhier
platform, but it should not hurt to enable PROGRAMMABLE_RESET_ADDRESS
to disable the mailbox and remove pointless plat_get_my_entrypoint.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>

Merge pull request #1233 from soby-mathew/sm/rm_uniphier_override ...

Allow API deprecation for uniphier platform

hikey: configure 4 MB of secure DRAM for OP-TEE Secure Data Path ...

Update the memory firewall configuration to reserve 4 MB of secure RAM
for use by the kernel and OP-TEE as the Secure Data Path pool.
Note that this address range (0x3E800000 - 0x3EC00000) falls in the
range already set aside by UEFI (which reserves the upper 32 MB of the
1GB DRAM for OP-TEE [1]) and was previously unused.

[1] https://github.com/96boards-hikey/edk2/blob/hikey/HisiPkg/HiKeyPkg/Library/HiKeyLib/HiKeyMem.c#L44
Signed-off-by: Jerome Forissier <jerome.forissier@linaro.org>
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Acked-by: Victor Chong <victor.chong@linaro.org>

hikey: configure the top 16MB of DRAM as secure ...

DRAM region 0x3f000000 - 0x3fffffff is reserved for OP-TEE and should
therefore be accessible only from secure world.

Signed-off-by: Jerome Forissier <jerome.forissier@linaro.org>
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Acked-by: Victor Chong <victor.chong@linaro.org>

rockchip/rk3399: Save and restore GIC ...

This adds calls to the GICv3 save/restore functions for the GIC
distributor and redistributor.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

rockchip/rk3399: Add udelay to wait loops ...

We were looping for MAX_WAIT_COUNT in several places without any
delays, so this adds the delays to make those loops more predictable.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

rockchip/rk3399: Fix QOS save/restore ...

The code was accidentally restoring the QOS on suspend and saving the
QOS on resume. This is the opposite of what we want.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

GICv3: Fix Dist restore for when the GIC is reset ...

If the GIC loses power during suspend, which the restore code was
written for, exit early in the post restore power sequence. This
prevents an assert from tripping, and the power sequence isn't needed
in this case anyways.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

rockchip/rk3399: Change PD_CTR_LOOP to 10000 ...

This brings ATF into line with the kernel on the timeout for power
domains turning on. We could actually timeout (when we shouldn't) on
resume when turning power domains on. The guaranteed maximum delay is
now 10ms.

Signed-off-by: Derek Basehore <dbasehore@chromium.org>

Correct the Makefile logic for disabling PIE ...

In the Makefile we use findstring to locate gcc toolchains
that have PIE enabled by default.

Unfortunately the result of findstring is compared against
an integer, 1, rather than a non-empty string; the logic to
disable PIE then doesn't get applied.

This patch fixes the flag test.

Fixes: f7ec31db2db3 ("Disable PIE compilation option")
Change-Id: I4cd2866974e313d6b408f9681311d78a208ab468
Signed-off-by: Steve Capper <steve.capper@arm.com>

Make div_round_up() correct for divisors that are not a power of 2 ...

The current div_round_up() implementation relies on round_up() which
only works correctly for boundaries that are a power of 2. It is
documented as such, but this still seems dangerously easy to overlook,
especially since many other environments (e.g. the Linux kernel) have a
similar macro without these limitations.

There is a different way to calculate this that can deal with all kinds
of divisors without other drawbacks, so let's just use that instead.

Change-Id: Id382736683f5d4e880ef00c53cfa23a2f9208440
Signed-off-by: Julius Werner <jwerner@chromium.org>

SPM: Declare explicit width based types in secure_partition_boot_info_t structure ...

The secure_partition_boot_info_t structure is used to communicate boot
parameters with the StandaloneMM code executing at S-EL0 through a
shared buffer. Certain data types used for members of this structure
are opaque with their size depending on the toolchain being used.

Declare the members of the structure with explicit width based data
types, which would maintain compatibility across toolchains.

Signed-off-by: Sughosh Ganu <sughosh.ganu@arm.com>

Allow API deprecation for uniphier platform ...

The `override ERROR_DEPRECATION = 1` setting in uniphier platform
makes deprecation of API difficult. Hence removing the same. This
flag should be specified on the command line if needed.

Change-Id: I8c82d8d13944e450a8cd636de3326137c04d7560
Signed-off-by: Soby Mathew <soby.mathew@arm.com>

poplar: Add support for recovery build ...

Signed-off-by: Victor Chong <victor.chong@linaro.org>
Acked-by: Shawn Guo <shawn.guo@linaro.org>
Tested-by: Shawn Guo <shawn.guo@linaro.org>

poplar: Enable emmc support ...

Let bl1 and bl2 have the ability to load images from emmc instead of
dram (mmap).

Signed-off-by: Victor Chong <victor.chong@linaro.org>
Acked-by: Shawn Guo <shawn.guo@linaro.org>
Tested-by: Shawn Guo <shawn.guo@linaro.org>

Hikey960: Enable invalid FIQ handling ...

When some interrupts are configured as group 0 in GICv2, these
interrupts trigger FIQ signal; this results in the Linux kernel panic
by reporting log: "Bad mode in FIQ handler detected on CPU0, code
0x00000000 -- Unknown/Uncategorized".  Unfortunately from kernel side it
has no permission to read the GIC register for group 0 interrupts so we
have no chance to get to know which interrupt is configured as secure
interrupt and cause the kernel panic.

For upper reason, this commit enables FIQ exception handling for
SPD_none case.  If the system has not enabled SPD the FIQ interrupt is
trapped into EL3 and the FIQ handler can report the interrupt number so
we can easily narrow down which FIQ introduce unexpected interrupt.
After enable SPD we can rely on SPD interrupt route model to handle FIQ.

Signed-off-by: Leo Yan <leo.yan@linaro.org>

Merge pull request #1229 from manojkumar-arm/manojkumar-arm/ca72-aarch32-reset-fix ...

lib/cpus: fix branching in reset function for cortex-a72 AARCH32 mode

Merge pull request #1227 from geesun/qx/emmc_macros ...

emmc: add macros CMD21, BUS_WIDTH_DDR_4 and BUS_WIDTH_DDR_8

coreboot: Add support for CBMEM console ...

coreboot supports an in-memory console to store firmware logs even when
no serial console is available. It is widely supported by
coreboot-compatible bootloaders (including SeaBIOS and GRUB) and can be
read by the Linux kernel.

This patch allows BL31 to add its own log messages to this console. The
driver will be registered automatically if coreboot support is compiled
in and detects the presence of a console buffer in the coreboot tables.

Change-Id: I31254dfa0c2fdeb7454634134b5707b4b4154907
Signed-off-by: Julius Werner <jwerner@chromium.org>

rockchip: Move to MULTI_CONSOLE_API ...

This patch changes all Rockchip platforms to use the new
MULTI_CONSOLE_API. The platform-specific plat_crash_console
implementations are removed so that the platform can use the ones from
the common platform code instead.

Also change the registers used in plat_crash_print_regs. The existing
use of x16 and x17 has always been illegal, since those registers are
reserved for use by the linker as a temporary scratch registers in
intra-procedure-call veneers and can never be expected to maintain their
values across a function call.

Change-Id: I8249424150be8d5543ed4af93b56756795a5288f
Signed-off-by: Julius Werner <jwerner@chromium.org>