/* mbed Microcontroller Library * Copyright (c) 2019 ARM Limited * SPDX-License-Identifier: Apache-2.0 * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #ifndef MBED_OBJECTS_H #define MBED_OBJECTS_H #include "cmsis.h" #include "PortNames.h" #include "PeripheralNames.h" #include "PinNames.h" #include "gpio_object.h" #include "stm32wbxx_ll_usart.h" #include "stm32wbxx_ll_tim.h" #include "stm32wbxx_ll_pwr.h" #include "stm32wbxx_ll_rtc.h" #include "stm32wbxx_ll_hsem.h" #ifndef FEATURE_BLE #error "BLE FEATURE CANNOT BE REMOVED" #endif #ifdef __cplusplus extern "C" { #endif struct pwmout_s { PWMName pwm; PinName pin; uint32_t prescaler; uint32_t period; uint32_t pulse; uint8_t channel; uint8_t inverted; }; struct spi_s { SPI_HandleTypeDef handle; IRQn_Type spiIRQ; SPIName spi; PinName pin_miso; PinName pin_mosi; PinName pin_sclk; PinName pin_ssel; #if DEVICE_SPI_ASYNCH uint32_t event; uint8_t transfer_type; #endif }; struct serial_s { UARTName uart; int index; // Used by irq uint32_t baudrate; uint32_t databits; uint32_t stopbits; uint32_t parity; PinName pin_tx; PinName pin_rx; #if DEVICE_SERIAL_ASYNCH uint32_t events; #endif #if DEVICE_SERIAL_FC uint32_t hw_flow_ctl; PinName pin_rts; PinName pin_cts; #endif }; struct flash_s { /* nothing to be stored for now */ uint32_t dummy; }; struct analogin_s { ADC_HandleTypeDef handle; PinName pin; uint8_t channel; }; #define HAL_CRC_IS_SUPPORTED(polynomial, width) ((width) == 7 || (width) == 8 || (width) == 16 || (width) == 32) struct gpio_irq_s { IRQn_Type irq_n; uint32_t irq_index; uint32_t event; PinName pin; }; struct port_s { PortName port; uint32_t mask; PinDirection direction; __IO uint32_t *reg_in; __IO uint32_t *reg_out; }; struct trng_s { RNG_HandleTypeDef handle; }; #if DEVICE_QSPI struct qspi_s { QSPI_HandleTypeDef handle; QSPIName qspi; PinName io0; PinName io1; PinName io2; PinName io3; PinName sclk; PinName ssel; }; #endif #ifdef __cplusplus } #endif /* STM32WB HAL doesn't provide some macro */ #define __HAL_RCC_PWR_CLK_DISABLE() #define __HAL_RCC_PWR_CLK_ENABLE() #define __HAL_RCC_PWR_IS_CLK_ENABLED() 1 #endif